Download Print this page

Blue Ox BX3776 Installation Instructions Manual

Baseplate

Advertisement

Quick Links

Please read BOTH these Installation Instructions and the General Towing
Instructions before attempting to install or operate this equipment.
®
1. Blue Ox
towing products and accessories
are intended to be installed by Blue Ox
Dealers who are familiar with our products and
have the equipment and knowledge to do "fi t
work." When necessary, Blue Ox
be found at
www.blueox.us
our Customer Care Department at
(888) 425-5382.
®
2. Many Blue Ox
Baseplates are designed to
use existing holes and hardware to mount
the baseplate to the towed vehicle. Even
though bolts are there, do not assume they
are adequate for baseplate mounting. Always
use hardware supplied in the hardware kit
or existing hardware specifi ed in the
Baseplate Towing Installation Instructions.
Confi rm the towability and pre-towing
procedures for your vehicle with
the owner's manual or contact the
vehicle's manufacturer for specifi c
towing procedures. You can also
contact REMCO for additional towing
information at 1(800)228-2481.
2008-09 Toyota Scion XB
Installation Instructions
Attachment Tab Height:
®
Attachment Tab Width:
®
Dealers can
or by contacting
Page 1 of 8
BX3776
(No Foglights)
Bolt Torque Specifi cations
Torque Specifi c
Torque Specifi c
Torque in Foot-Pounds per Metric Bolts
e in Foot-Pounds per Met
e in Foot-Pounds per Me
n
Bolt Size Grade 8.8 Grade 10.9
t Size Grade 8.8 Grade
t
ize
e G G rade 8.8 G
6MM
6MM
6
M
6
6
8
8MM
8MM
16
16
10MM
0M
0MM
31
31
12MM
MM
MM
54
54
14MM
89
89
Bolt Torque Specifi cations
orque Specifi
orque Specifi
Torque in Foot-Pounds per Inch Bolts
in Foot-Pounds per Inc
in Foot-Pounds per In
Bolt Size
Grade 5
1/4"
10
5/16"
19
3/8"
33
7/16"
54
1/2"
78
5/8"
154
WARNING
!
Failure to read and follow these instructions
could result in separation of the towed vehicle
from the tow bar, causing property damage,
loss of towed vehicle, personal injury or death.
292-2984
12 1/2"
18"
M
8
rad
8
8
8
22
22
40
40
0
7
7
70
117
Grade 8
14
29
47
78
119
230
3/2/09

Advertisement

loading
Need help?

Need help?

Do you have a question about the BX3776 and is the answer not in the manual?

Questions and answers

Summary of Contents for Blue Ox BX3776

  • Page 1 1. Blue Ox towing products and accessories Attachment Tab Height: 12 1/2” ® are intended to be installed by Blue Ox Attachment Tab Width: 18” Dealers who are familiar with our products and have the equipment and knowledge to do “fi t ®...
  • Page 2: Parts List

    (In most cases it will be Grade 5, please reference the parts list above). Replacement parts may be ordered through your nearest Blue Ox® Dealer or Distributor. Page 2 of 8...
  • Page 3: Installation Instructions

    BX3776 2008-09 Toyota Scion XB (No Foglights) Installation Instructions Vehicle Weight: Installation Instructions: Motorhome mount tow bars are recommended for use with this baseplate. Due to the design of the removable tabs, the RangeFinderII, Adventurer, and Ambassador tow bars can not be used. The Acclaim tow bar may be used, but will not fold and store on the front of the vehicle.
  • Page 4 BX3776 2008-09 Toyota Scion XB (No Foglights) Installation Instructions 4. Using 10MM socket, remove one metric bolt 5. Remove eight metric bolts from lower edge just forward of the front tire on bottom side of of fascia all the way around using a 10MM fascia.
  • Page 5 BX3776 2008-09 Toyota Scion XB (No Foglights) Installation Instructions 9. On the driver’s side, using a fl at screwdriver remove the push pin holding the vent tube. Also pull out the clip (grey arrow) from wire loom. Move the vent tube out of the way.
  • Page 6 BX3776 2008-09 Toyota Scion XB (No Foglights) Installation Instructions 13. On the driver’s side, the back two bolts (white 14. On the passenger side, start a 6MM-1.0 x arrows) are 3/8-16 x 1” hex bolts and 3/8” lock 30MM hex bolt in existing hole, the lower washers with 3/8-16 hex nuts.
  • Page 7 BX3776 2008-09 Toyota Scion XB (No Foglights) Installation Instructions 20. Reattach washer reservoir, use 6MM-1.0 x 19. To give reinforcement to frame webbing, using 30MM hex bolts and a 1/4” fl at washer. In the 13/32” drill bit, drill two holes, insert 3/8-16 the top, use a 5/8”...
  • Page 8 DEALER or INSTALLER: Be certain the user receives the instruction sheets for their products. Blue Ox is committed to providing you with Install the tow bar and safety cables exceptional customer care throughout your lifetime according to the instructions provided in their with our products.