Siemens S1 RKM 10014 Instructions For Use Manual page 43

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 25
Things that can save you from
making unnecessary phone calls
What to do if ...
... the appliance doesn't
work ...
... the appliance does not
work and the red light
flashes on and off ...
... the red light comes on
frequently ...
... condensation water is
produced on the air
outlet grille ...
... the appliance does not
work and the red and
green lights flash on and
off alternately ...
The following procedures can help you solve a
number of small problems and save you from
contacting our Technical Service unnecessarily.
If after performing the procedures described the
problem persists or happens again, then contact
our specialised technicians.
Make sure that the appliance is plugged in
properly.
Make sure that there is power in the mains
electricity supply and all the fuses are in working
order.
Select a lower temperature with the
If you wish to use the remote control at a
distance, make sure that the batteries have not
run out. If they have, then replace them or insert
the remote control in the panel housing.
If you wish to use the remote control housed on
the appliance, then make sure that the power
supply contacts are clean and the remote control
has been inserted properly.
Place the appliance on a flat surface. If the pilot
light still doesn't go out, then empty the
appliance's internal water tank. (See instructions
for Temperature Control).
Make sure that the drainage stopcock is set to
the right position.
This is normal in conditions of high relative
humidity. The appliance is not affected.
Get in touch with the Service Centre. A fault has
occurred to the thermal probes. Tell your Official
Service Centre the make of your appliance.
<
button.
43

Advertisement

Table of Contents
loading

Table of Contents