The recording system in your MD recorder is radically
different from those used in cassette and DAT decks and is
characterized by the limitations described below. Note,
however, that these limitations are inherent to the MD
recording system and are not a result of mechanical
"Can't REC" is displayed before the maximum
recording time (60 or 74 minutes) has been reached
Once 255 tracks have been recorded on one MD, "Can't
REC" is displayed regardless of the total recorded time.
More than 255 tracks cannot be recorded on one MD. To
continue recording, erase unnecessary tracks, combine
tracks to reduce the total number of tracks, or use another
"Disc Full" is displayed before the maximum number of
tracks (255) have been recorded
During Automatic Track Marking, fluctuations in emphasis
within songs may be interpreted as song intervals,
increasing the song count and causing "Disc Full" to be
The remaining recording time does not increase even
after erasing numerous short tracks
Tracks under 12 seconds in length are not counted and so
erasing them may not lead to an increase in the recording
"TOC Reading" is displayed continuously
The "TOC Reading" display lasts longer than normal when
a brand new (blank) disc is inserted.
The total recorded time and the remaining time on the
MD do not total to the maximum recording time
Recording is done in minimum units of 2 seconds
each, no matter how short the material. The contents
recorded may thus be shorter than the maximum
recording capacity. Disc space may also be further
reduced by scratches.
This unit displays the length of the largest continuous
blank area as the remaining time. Therefore, if there
are several separate blank spaces, the remaining time
will only display a time equivalent to the largest
continuous blank space.
If there is a 1 minute blank space and a 2 minute blank
space, the remaining time display will be "2" minutes. If
you then record 1 minute and 30 seconds of the 2
minute blank, the remaining time display will become
MD SYSTEM LIMITATIONS
Tracks created through editing may exhibit sound
dropout during search operations.
Track numbers are not recorded correctly
Incorrect assignment or recording of track numbers may
result when CD tracks are divided into several smaller
tracks during digital recording.
It is not possible to erase part of a track using the A-B
This unit organizes the audio data in sound groups and
clusters. The minimum size of these units varies according
to the number of channels being recorded. For a 2 channel
(stereo) recording, a single unit may not consist of less
than 10 seconds of sound. For a 1 channel (mono)
recording, a single unit may not consist of less than 20
seconds of sound.
Limitations when recording over an existing track
• The correct remaining recording time may not be
• You may find it impossible to record over a track if that
track has been recorded over several times already. If
this happens, erase the track using the Erase Function.
• The remaining recording time may be shortened out of
proportion to the total recorded time.
• Recording over a track to eliminate noise is not
recommended since this may shorten the duration of the
• You may find it impossible to label a track while
recording over it.
The correct recorded/playing time may not be displayed
during playback of monaural-format MDs.