Random Tape Programming - Yamaha 585 Owner's Manual

TRACK PROGRAMMING FOR RECORDING

Random Tape Programming

The unit will automatically program tracks on a disc in
random sequential order for recording to tape.
1 Follow steps 1 – 3 on page 17.
2 Press the RANDOM button.
The unit will automatically program tracks for side A
and side B separately considering the tape's total time.
* The programmed track numbers and the total number
of tracks for side A and B are displayed for a short
time.
Start recording on the tape deck and press the
3
w button at the same time.
The unit will pause at the end of side A of the
4
tape.
Turn the tape over to side B. Resume recording and, at
the same time, press the w or d button.
20
E-
DISC SCAN DISC SKIP
REPEAT RANDOM
2
3
RANDOM
Notes
• Because the programmed data changes every time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
• It is recommended that you use a tape that is slightly longer
in length than the CD you are recording, because the
programmed tracks on a CD may not fit properly into the
time allowed on each half of the tape.
• CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in steps 3 and 4, press the SYNCHRO button
and then press the w button. Recording automatically begins.
(For details, refer to page 16.)
Display information during programming
1 2 3 4 5
4
1
1 Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished,
and then it is replaced by the number of the first
programmed track for side A.
2 Shows the total time of programmed tracks for each side.
3 Shows the programmed track numbers for each side.
3
PROG
1 3 5
7
1 3 : 0 0
2