Operation And Important Riding Points; Starting The Engine - Yamaha YZF-R6T(C) Owner's Manual

WARNING
G Become thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly un-
derstand.
G
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
G
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.

OPERATION AND IMPORTANT RIDING POINTS

EAU15950

Starting the engine

EWA10270 In order for the ignition circuit cut-off
system to enable starting, one of the
familiar following conditions must be met:
G The transmission is in the neutral
position.
G
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
WARNING
G
Before starting
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-20.
G
Never ride with the sidestand
down.
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to " ".
CAUTION:
The following warning lights and in-
dicator light should come on for a
few seconds, then go off.
G Oil level warning light
G Fuel level warning light
EAU16251
If a warning or indicator light does
not go off, see page 3-2 for the corre-
sponding warning and indicator
light circuit check.
EWA10290
NOTE:
the engine,
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
to the procedure
Yamaha dealer check the electrical cir-
cuit.
NOTE:
If the engine fails to start, release the
start switch, wait a few seconds, and
ECA11830
then try again. Each starting attempt
should be as short as possible to pre-
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
5-1
G
Coolant temperature warning
light
G Shift timing indicator light
G Engine trouble warning light
2. Shift the transmission into the neu-
tral position.
3. Start the engine by pushing the
start switch.
5