Table of Contents
Advertisement
LED Indicator
Xerox DP1015 User's Guide
To turn off the projector power
1. Press the
Power button on the projector or remote control to
turn off the projector lamp.
An on-screen message appears asking if you're sure you want
to turn off the lamp.
2. Press the
Power button again to confirm.
If you don't press the button within ten seconds, the message
disappears and the lamp remains lit. This convenient design is
in case you accidently press the
of a show and do not want to turn off the projector.
If you do press the
LED indicator flashes rapidly. Then the projector automatically
shuts itself down.
3. Do not turn on the projector again for at least two minutes.
When the LED indicator is again flashing slowly it is safe to turn
the lamp back on.
4. After two minutes, disconnect the power cord.
NOTE:
Do not disconnect the power cord until the projector's
cooling fan stops (about two minutes). This protects the lamp
from overheating and possible damage
•
Slow flash—Normal operation; the power cord is plugged in.
•
Steady light, not flashing—Normal operation; the lamp power
is on and the projector is operating normally.
•
Rapid flashing during lamp shutdown—Normal operation;
the fan runs for about 30 seconds to cool down the lamp.
•
Rapid flashing while the lamp is powered—Warning: either
the lamp has overheated and the fan runs automatically, or the
fan has malfunctioned. You cannot turn off the power to the
lamp until it has cooled down.
Connecting the Projector
Power button in the middle
Power button a second time, the
LED Indicator
13
Advertisement
Table of Contents
