In this chapter you will find information and instructions
needed to install the burner and system components.
Handling & Storage
• Make sure that the area is clean.
• Protect the components from the weather, damage,
dirt and moisture.
• Protect the components from excessive
temperatures and humidity.
• Take care not to drop or damage components.
• Make sure that the components are clean and free
• Store the components in a cool, clean, dry room.
• After you have made sure that everything is present
and in good condition, keep the components in the
original package as long as possible.
Approval of Components
Limit Controls & Safety Equipment
All limit controls and safety equipment must comply with
all applicable local codes and/or standards and must be
listed for combustion safety by an independent testing
agency. Typical application examples include:
• American: NFPA 86 with listing marks from UL, FM,
• European: EN 746-2 with CE mark from TuV,
All the electrical wiring must comply with all applicable
local codes and/or standards such as:
• NFPA Standard 70
• CSA C22
All the gas piping must comply with all applicable local
codes and/or standards such as:
• NFPA Standard 54
• ANSI Z223
• EN 746-2
Where to Get the Standards:
The NFPA Standards are available from:
National Fire Protection Agency
Quincy, MA 02269
The ANSI Standards are available from:
American National Standard Institute
New York, NY 10018
The UL Standards are available from:
333 Pfingsten Road
Northbrook, IL 60062
The FM Standards are available from:
1151 Boston-Providence Turnpike
PO Box 9102
Norwood, MA 02062
Information on the EN standards and where to get
them is available from:
Comité Européen de Normalisation
Comité Européen de Normalisation Electronique