Installing A Standby Power Supply - Dell EMC NX4 Series Manual

Replacing a standby power supply
Hide thumbs

Advertisement

Installing a standby power supply

1. Remove the SPS from its packaging.
2. From the front, slide the SPS onto the tray and into position
3. From the rear, secure the SPS with four screws that you saved either from removing the
back plate (if you are adding a second SPS) or from removing from a failed SPS (if you
are replacing an SPS).
Figure 6. Installing a standby power supply
Installing a standby power supply
(Figure 6 on page
Installing a standby power supply
11).
11

Advertisement

loading

  Related Manuals for Dell EMC NX4 Series

This manual is also suitable for:

Emc ax4-5f8

Table of Contents