Table of Contents
Advertisement
Finishing
PCL Paper Source Command
Mixed Stacking
6-4
•
All finishing limitations and restrictions at the printer will apply
to a subset segment.
Use the PCL Paper Source command <esc & 1 # H> to program
a PCL print job to use a specific paper. The PCL decomposer on
the DocuSP Controller reads the paper source command and,
using the PCL Paper Sources option in the Queue Properties,
maps the command to the appropriate paper. The number code
corresponds to the following PCL Paper Source programmed in
Queue Properties.
To program the PCL Paper Source, use the following guidelines:
•
Standard: <ESC>&11H
•
Manual Paper Feed: <ESC>&13H
•
Manual Envelope Feed: <ESC>&13H
•
Lower: <ESC>&14H
•
Large Capacity: <ESC>&15H
•
Envelope Feed: <ESC>&16H
Mixed stacking allows all completed jobs with different finishing
to accumulate in the stacker until it is full or until the operator
empties it.
The types of finishing that can be mixed include stitching,
binding, and unfinished. The mixed stack can also include
banner pages. The stacker can hold between 12 and 18
subsets of different types of finishing in the stacker before
unloading.
Mixed stacking is enabled upon installation but can be disabled if
you choose to do so. If you wish to have it enabled at a later
date, a Xerox Service Representative must assist you.
System Guide
Common Controller
Advertisement
Table of Contents
