178
Image Position
This parameter enables you to change the location of the entire printed
image on the sheet (simplex or duplex).
uses the following terminology:
Image position
•
the edge of a sheet at which printing stops, near the rear of the
Rear:
printer
•
the edge of a sheet at which printing begins
Lead:
The page's lead and rear edges are determined just after the page is printed
out, before making any change in page orientation.
Select one of the following:
To print your job in the center of the page, click
To set page offsets, click the directional arrows or type
values
Lead
To apply page offset values to both odd and even pages, select the
Same on both sides
Tip: Use this option to move duplex page data away from the spine.
Image Scale
Perform one of the following:
To print the image original size, select
To fit the image to the selected paper size, select
To custom size the image, select
which you would like to proportionally increase or decrease the
image size
Rotate 180
To rotate your job by 180°, select
Appendix A– Setting Parameters
check box.
100%
Custom
.
Yes
Center
and
Rear
(default)
Fit to Paper
and type the percent by