Download Print this page

Operation - Husqvarna CF 11M Operator's Manual

Frequency converter
Hide thumbs

Advertisement

If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
Use personal protective equipment. Refer to
Personal protective equipment on page 5 .
Clean the product to remove dangerous material
before you do the maintenance.
Disconnect the product from the power source
before you do the maintenance.
Do not change the product. Modifications that are
not approved by the manufacturer can cause serious
injury or death.
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
Read the operator's manual carefully and make sure
that you understand the instructions.
Do the daily maintenance. Refer to
maintenance on page 7 .
Make sure that the installation of the product agrees
with local safety regulations.
Make sure that the mains voltage agrees with the
rating plate on the product.
Make sure that the cable installation agrees with IP
classification shown on the rating plate of the
product.
To start the product
CAUTION: Read the electrical specifications
Technical data on page 9 or on the
in
rating plate of the product before you
connect a concrete vibrator.
1. Push the red OFF button on the product.
2. Connect the product to a grounded power outlet.
3. Make sure that the concrete vibrator is off.
4. Put the power plug of the concrete vibrator into a
power outlet on the product.
5. Push the green ON button on the product.
CAUTION: Do not start the product with
a connected concrete vibrator in ON
position.
6

Operation

6. Push the ON button on the connected concrete
Maximum number of connected
concrete vibrators
Daily
Type
AX36
AX40
AX48
AX56
AX65
AX90
Vibra-
star 40
Vibra-
star 50
Vibra-
star 60
To stop the product
1. Push the OFF button on the connected concrete
2. Push the red OFF button.
by the manufacturer, can cause serious injury or
death.
Replace damaged, worn or broken parts.
Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
Let an approved service agent do servicing on the
product regularly.
vibrator.
CAUTION: The power consumption of the
connected concrete vibrators must not be
more than the output capacity of the
product. Refer to the table below for more
information.
CF11
CF25
M
M
1
2
1
2
1
2
N/A
2
N/A
N/A
N/A
N/A
1
2
1
2
1
2
vibrator.
CF67T
CF25T
CF67T
CI4P
2
4
4
2
4
4
2
4
4
2
4
4
1
3
N/A
1
3
N/A
2
4
4
2
4
4
2
4
4
1381 - 002 - 12.03.2020

Advertisement

loading

This manual is also suitable for:

Cf 25mCf 25tCf 67tCf 67tci4p