vibrators. The product is used connected to a power
outlet. The product operates as a transformer to make
sure that the operation of the concrete vibrators is safe.
The green and red buttons on the product have an
overload protection. The product stops automatically if
the load is too high.
The model CF 67T has thermal winding protection to
prevent overload in the electrical motor.
The power outlets on model CF67TCI4P can be
adjusted between 10–18 A.
The product is for professional operation only. The
product, together with the AX and Vibrastar concrete
vibrators, is used for concrete vibration. Do not use the
product for other tasks.
Symbols on the product
WARNING: This product can be dangerous
and cause serious injury or death to the
operator or others. Be careful and use the
Read the operator's manual carefully and
make sure that you understand the
instructions before you use the product.
The product or package of the product is not
domestic waste. Recycle it at an approved
disposal location for electrical and electronic
This product is in compliance with applicable
Note: Other symbols/decals on the product refer to
special certification requirements for some markets.
1381 - 002 - 12.03.2020
1. Product type
2. Serial number
3. Speed, rpm
4. Input voltage, V
5. Input current, A
6. Input phase
7. Input frequency, Hz
8. Output voltage, V
9. Output current, A
10. Output phase
11. Output frequency, Hz
12. Duty cycle
14. Insulation class
15. IP classification
16. Production year
17. Power factor
18. Maximum ambient temperature
19. Kilovolt-ampere, KVA
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
the product is incorrectly repaired.
the product is repaired with parts that are not from
the manufacturer or not approved by the
the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
the product is not repaired at an approved service
center or by an approved authority.