Advertisement
Maintenance:
Grease/Lubrication Points:
Each area where the arrows point indicates where a grease/Lubrication point is located. Stickers on the
Spreader body further indicate where grease/lubrication points are located.
The spreader should be greased using a grease gun every 25-30 loads and before storage. Make sure to grease all
available grease areas before any period of storage. Use caution to not over grease fittings as it may damage the
bearings.
When greasing the hubs for the ABI Classic Ground Drive Spreader use caution to make sure you do not over grease
the hubs. You will want to put about 2-3 full pumps of grease into each hub using a manual grease gun every 30-35
loads. Hubs may need to be cleaned out once a year to remove old grease build up.
ABI(
Absolute Innovations, Inc.
ABI Classic Spreader Setup Guide
)
-
855-211-0598
-
www.abiattachments.com
12
Advertisement
