Table of Contents
Advertisement
en
Safety systems
Safety systems
Start lock-out
See "Overview of the operating positions"
table. In position 1 the appliance cannot be
switched on. The appliance can be switched
on in position 2-4 only:
■ when the bowl has been inserted and
rotated as far as possible
or
■ the tool drive cover has been attached.
In position 5 the appliance can only be
switched on when the tool drive cover
has been attached. The blender must be
screwed in all the way.
In position 6 the appliance cannot be
switched on unless the mincer and adapter
have been attached correctly (see mincer
operating instructions).
Restart lock-out
If the power is interrupted, the appliance
remains switched on but the motor does
not start running again when the power is
restored. To restart the appliance, turn the
rotary switch (3) to 0, then switch on the
required setting.
Overload protection
If the motor switches itself off while the
appliance is being used, the overload
protection feature has been activated.
Possible causes:
– very large amounts of ingredients,
– appliance operated too long.
If a safety system is activated, see
"Troubleshooting".
18
11_MUMX50GXCN_8001018585_02-ohneZubehör.indb 18
Overview
The operating instructions describe several
models, see also overview of models
(Fig. K).
Please fold out the illustrated pages.
Figure A: Base unit
1 Release button
2 Multi-function arm
"Easy Armlift" – supports the simple and
effortless operation of the multi-function
arm (see "Operating positions").
3 Rotary switch
When the appliance has been switched
off (0 position), it automatically runs
to the optimum position for changing
the tools (tool change position). This
position also facilitates filling the bowl
with ingredients, as no ingredients can
stick to the tools ("Easy fill" position).
0 = Stop
M/S = M stands for the pulse switch at
maximum speed, hold down switch for
required blending duration.
S stands for automatic SensorControl.
When the SensorControl (4) is
activated, the appliance automatically
switches off when the optimum result is
obtained.
Settings 1-7, Operating speed:
1 = low speed – slow,
7 = high speed – fast.
4 Operating buttons on the automatic
SensorControl
See Section "Working with
SensorControl".
5 Drive cover
To remove the drive cover, press on the
front area and remove cover.
6 Drive for
– continuous-feed shredder *,
– citrus press * and
– grain mill *.
When not in use, attach the drive cover.
7 Drive for tools (stirrer, whisk,
kneading hook) and mincer *
8 Drive cover
14.09.2015 12:37:35
Advertisement
Chapters
Table of Contents
