Parts and Function
Buttons and display of the remote controller.
When unit is started for the first time after
replacing batteries in remote controller,
clock should be adjusted as following:
Press CLOCK button, "AM" or "PM" flashes.
to set correct time. Each press
will increase or decrease 1 min. If the button
is kept depressed, time will change quickly.
After time setting is confirmed, press SET,
"AM" and "PM" stop flashing while clock
After replacing with new batteries,
remote controller will conduct self-check,
displaying all information on LCD. Then,
it will become normal
Remote controller's operation
When in use, put the signal transmission head
directly to the receiver hole on the indoor unit.
The distance between the signal transmission
head and the receive hole should be within 7m
without any obstacle as well.
Don't throw the controller, prevent it from being
When electronic-started type fluorescent lamp or
charge-over type fluorescent lamp or wireless
telephone is installed in the room, the receiver is
apt to be disturbed in receiving the signals so the
distance to the indoor unit should be shorter.
Loading of the battery
Load the batteries as illustrated.
2 R-03 batteries, resetting key (cylinder)
Remove the battery cover
Slightly press" " and push down the cover.