2: Configuring The Printer - Honeywell NOTIFIER NCA-2 Instruction Manual

Installation
DB-25 connector on
PRN Series Printer
DB-25 connector on
Keltron Printer VS4095/5*
3. If installing a Keltron Printer VS4095/5, connect 24 VDC non-resettable power from a UL-listed power supply to the Keltron
printer as shown in Figure 3.15 (14 AWG).
4. If installing a PRN series printer, plug it into your AC power source.
Note: The PRN series of printers require a primary AC power source. Refer to the Manufacturer's Installation Guide for additional
information.
If required for the fire alarm system configuration (for example, a Proprietary Fire Alarm System), a remote printer requires a
secondary power source (battery backup). Because a secondary power source is not provided, use a separate Uninterruptable Power
Supply (UPS) that is UL-listed for Fire Protective Signaling.
5. Plug the DB-25 or DB-9 connector end of the custom cable into the EIA-232 port of your printer. Tighten securely.
6. Configure the printer as described in Section 3.14.2 "Configuring the Printer".
3.14.2 Configuring the Printer
Refer to the documentation supplied with your printer for instructions on configuring your printer.
32
Note: Outputs are power-limited.
TB5 on NCA-2
TB5 on NCA-2
Figure 3.15 Printer Connections
DB-9 connector on
PRN Series Printer
5 3 2
TB5 on NCA-2
Keltron Printer VS4095/5
power connections*
DC IN + DC IN -
TB3 of AMPS-24/E
*Note: VS4095/5 is not ULC-listed.
NCA-2 Manual — P/N 52482:M5 03/20/2019
Installing Printers