Maintenance; Tool Lubrication - Bosch CCS180 Operating/Safety Instructions Manual

Bosch circular saw operating/safety instructions
Table of Contents

Advertisement

Available languages

Available languages

BM 2610001787 07-08
The purpose of the green light is to indicate that
the battery pack is fast-charging. It does not
indicate the exact point of full charge. The light
will stop blinking in less time if the battery pack
was not completely discharged.
If the green indicator light is "ON", the battery
pack cannot accept a charge.
• Check to make sure the battery pack is
inserted into the charger properly.
FIG. 16
GREEN LIGHT
NO USER SERVICEABLE
!
WARNING
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard. We recom-
mend that all tool service be performed by a
Bosch Factory Service Center or Authorized
Bosch Service Station. SERVICEMEN:
Disconnect tool and/or charger from power
source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased tool
performance or significantly shorter running
time between charges then it is time to
replace the battery pack. Failure to do so can
7/24/08
10:42 AM

Maintenance

Service
Page 17
• Clean the contacts of the charger or battery
pack (e. g. by inserting and removing the
battery several times) or replace the battery
pack, as required.
When the battery pack is fully charged, unplug
the charger (unless you're charging another
battery pack) and slip the battery pack back into
the tool.
BATTERY
PACK
cause the tool to operate improperly or
damage the charger.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated
and is ready for use.
D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six
months. Only a genuine Bosch replacement
motor specially designed for your tool should
be used.
BEARINGS
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating and
motor failure.
-17-
CHARGER

Advertisement

Table of Contents
loading

Table of Contents