Depth Adjustment; Safety Switch; Operating Instructions - Bosch CCS180 Operating/Safety Instructions Manual

BM 2610001787 07-08
Disconnect battery pack from tool. Loosen the
depth adjustment lever located on the right
side of the tool. Hold the foot down with one
hand and raise or lower saw by the handle.
CALIBRATED DEPTH
BRACKET

SAFETY SWITCH

The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 5). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate. (See Switch & General Cuts
on page 12.)
FIG. 5
SAFETY SWITCH
RELEASE BUTTON
7/24/08 10:42 AM

Operating Instructions

DEPTH ADJUSTMENT

FIG. 3
DEPTH
ADJUSTMENT
LEVER
TRIGGER
Page 11
Tighten lever at the depth setting desired.
Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
90° CUTTING ANGLE CHECK
Disconnect battery pack from tool. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on quadrant,
retighten lever and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 6). Make adjustments by
turning the small alignment screw from bottom
side of foot, if necessary (Fig. 7).
FIG. 6
BEVEL
ADJUSTMENT
KNOB
FOOT
BLADE
-11-
FIG. 4
FIG. 7
ALIGNMENT
SCREW