Table of Contents
Advertisement
Quick Links
Amplifier
Amplifier
Installation
stallatio
stallat
Guide
Contents:
Guarantee and Warranty · · · · · · · · · · · · · · · · · · · · · · · ·
How it Works · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · 2
Before Getting Started · · · · · · · · · · · · · · · · · · · · · · · · · · 3
Installation Overview · · · · · · · · · · · · · · · · · · · · · · · · · · · 3
Installing the Antenna (Vehicle) · · · · · · · · · · · · · · · · · · · 4
Installing the Antenna (Home/Offi ce) · · · · · · · · · · · · · · · 6
Installing the Universal Connector · · · · · · · · · · · · · · · · · 7
Powering Up the Amplifi er · · · · · · · · · · · · · · · · · · · · · · · 8
Warnings and Recommendations · · · · · · · · · · · · · · · · · 9
About Wilson Electronics · · · · · · · · · · · · · · · · · · · · · · · · 10
Amplifi er Specifi cations · · · · · · · · · · · · · · · · · · Back Cover
SIGNALBOOST™
Dual-Band
Cellular / PCS
Amplifi er
!
Warning: This manual contains
important safety and operating information.
Please read and follow the instructions
in this manual. Failure to do so could be
hazardous and result in damage to your
amplifi er.
1
Wilson
®
Electronics, Inc.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Wilson Electronics Car Amplifier
-
Page 1: Table Of Contents
Warnings and Recommendations · · · · · · · · · · · · · · · · · 9 About Wilson Electronics · · · · · · · · · · · · · · · · · · · · · · · · 10 Amplifi... - Page 2 Returned Material Authorization (RMA) number supplied by Wilson Electronics. Wilson shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or replaced product back to the original consumer.
-
Page 3: How It Works
NOTE: Use of this amplifi er with an antenna gain higher than 6.12 dBi is in violation of FCC regulations for which the offender is fully liable. All Wilson mobile antennas are 6.12 dBi or less. Mini Magnet-Mount... -
Page 4: Before Getting Started
Read through the instructions, visualize where all the equipment will need to be installed and do a soft installation before mounting any equipment. If you do not understand the instructions in full, please contact Wilson Technical Support at 866-294-1660. -
Page 5: Vehicle Installation
Installing the Antenna To receive the best cell signal, select a location in the center of the vehicle’s roof at least 12 inches away from any other antennas and free of obstructions. Carefully Run Cable Pull Down Door Seal Tuck Cable Under Seal Vehicle Installation The antenna must be installed vertically. -
Page 6: Installing The Signalboost™ Amplifi Er (Vehicle)
Vehicle Installation Installing the Wilson SIGNALBOOST™ Amplifi er Warning: Do not plug in the DC power supply until the antenna and universal connector cables are attached to the amplifi er. Select a location to install the amplifi er that is away from excessive heat, direct sunlight or moisture and that has proper ventilation. -
Page 7: Home/Offi Ce Installation
To receive the best cell signal, select a window location at least 12 inches away from any radio or television antennas and free of obstructions. Installing the Wilson SIGNALBOOST™ Amplifi er Home/Offi ce Installation Using the suction cups, position the optional mounting bracket on the window at a height convenient to where the amplifi... -
Page 8: Installing The Universal Connector
For cell phones with an external antenna, place the universal connector directly below the phone’s original antenna. (Figure 2) If you have any questions as to the location of the antenna on your phone, call Wilson Technical Support at 866-294-1660 or visit www.wilsonelectronics.com. Universal... -
Page 9: Powering Up The Amplifi Er
“Power” and insert the plug end into a standard wall outlet. Warning: Use only Wilson power supply units. Use of a non-Wilson product may damage your equipment. The amplifi er may remain on all the time. However, leaving the amplifi er on in a vehicle when it is not running can discharge the battery in a day or two. -
Page 10: Warnings And Recommendations
Use of this amplifi er with an antenna gain higher than 6.12 dBi is in violation of FCC regulations for which the offender is fully liable. All Wilson mobile antennas are 6.12 dBi or less. Recommended amplifi er installation locations for a vehicle are: •... -
Page 11: About Wilson Electronics
All products are engineered and assembled in the company’s 50,000-square-foot headquarters in St. George, Utah. Wilson has product dealers in all 50 states as well as Canada and Mexico, Central and South America. -
Page 12: Amplifi Er Specifi Cations
3301 East Deseret Drive, St. George UT 84790 Phone: 866-294-1660 CDMA EDGE AMPS CDMA EDGE AMPS Number of channels Wilson Electronics, Inc. For additional Technical Support visit www.wilsonelectronics.com Fax: 435-656-2432 Dual Band 800/1900 MHz Specifi cations 811210 FME-Male 50 Ohms 5 x 3.5 x 1.2 inch or 12.7 x 8.9 x 3 cm...
Need help?
Do you have a question about the Car Amplifier and is the answer not in the manual?
Questions and answers