SIGMATEK C-DIAS Series Manual

C-DIAS Temperature Sensing Module
8 x Thermocouple inputs
8 x digital outputs+24 V
This analog input module is used for the recording of
temperatures.
The following thermocouple inputs can be connected:
Fe-CuNi (Type J) ... 0 – 600 ° C
NiCr-Ni (Type K) ... 0 – 800 ° C
FeCu-Ni (Type L) ... 0 – 600 ° C
In addition, 8 digital +24 V outputs (positive switching) are
available. The supply voltage is monitored for under voltage.
Technical Data
Analog channel specifications
Number of channels
Measurement range
Measurement value
Resolution
Conversion time per channel
Applicable sensor type
according to
DIN 43710
Input filter
Common mode range
Sensor type for cold junction
Cold junction
Precision of Analog channel
measurement
19.04.2012
C-DIAS TEMPERATURE SENSING MODULE
0 – 6000 or
0 – 8000
0.5 s
±0.70 % of the maximum measurement value
(with use of KTY10-62 terminal compensation sensors)
8
Type J (0 - 600 °C; 0 – 33.1 mV)
Type K (0 - 800 °C; 0 – 33.3 mV)
Type L (0 - 600 °C; 0 – 33.7 mV)
An open input returns a value of -
0.15 ° C / 12 Bits
1 ms
FeCu-Ni (Type J)
NiCr-Ni (Typ K)
FeCu-Ni (Typ L)
±10 V
KTY10-62
-20 to 80 ° C
CAI 888
CAI 888
2147483631
Low pass 3 system
Page 1