Electrolux EXN09C58HW User Manual page 7

4.2 Location of the Remote Controller
4.3 Battery installation/replacement
• Keep the remote controller where its
signal can reach the receiver of the
indoor unit (a maximum distance of
8 m is allowed).
• When the remote controller sends
out a signal, the symbol " " will blink
for about 1 second on the display.
The indoor unit will acknowledge
the signal with beep sound when
it receives an effective signal.
• Slide the back cover from the
remote controller, exposing the
battery compartment and insert two
new alkaline dry batteries (2x AAA
1.5 Volt). Make sure that the polarity
of (+) or (-) is installed correctly.
• Slide the battery compartment cover
back on.
• When changing batteries,
do not use old or varied
ones, otherwise, it may
cause problems with the
remote controller.
• If the remote controller is not
used for a long time, remove
the batteries as old batteries
may leak or corrode and
damage the remote controller.
• The battery life during normal
use is about six months.
• If the remote controller
does not operate normally,
please remove and refit the
batteries. If abnormal operation
continues, replace with
new batteries.
ENGLISH 7