White Outdoor 235 Operator's Manual page 6

Single-stage snow thrower
Hide thumbs Also See for 235:
Table of Contents

Advertisement

3
Setup And
Adjustment
WARNING
Disconnect the spark
plug wire and ground
it against the engine
to prevent unintended
starting.
NOTE:
This Operator's Manual
covers several models.
Snow thrower features
vary by model. Not
all features discussed
in this manual are
applicable to all snow
thrower models.
NOTE:
All references to left
or right side of the
snow thrower is
from the operating
position only.
IMPORTANT:
Do not use the
chute handle to lift
the snow thrower.
Figure 3-1
2
Figure 2
Chute Handle
Figure 3
NOTE: This Operator's Manual covers several models.
Snow thrower features vary by model. Not all features
discussed in this manual are applicable to all snow
thrower models.
1
NOTE: All references to left or right side of the snow
thrower is from the operating position only
Carton contents are listed below with part numbers in
2
parentheses.
1. Two Ignition Keys (725-0201)
2. 2.6 oz Bottle of 2 Cycle Oil (737-04037)
3. Extension Cord (if so equipped) (629-0236)
Remove packing material, if present.
1. Making sure not to pinch the cable in the process,
2. Tighten the wing knobs to secure the handle in place
3
1
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way down.
To pivot it upward, proceed as follows:
1. Turn the chute until the chute opening is facing
2. Pivot the upper chute upward over the lip on the lower
3. Resecure with the hardware just removed. If installed
IMPORTANT: Do not use the chute handle to lift the
snow thrower.
6
Contents of Carton
WARNING: Disconnect the spark plug
wire and ground it against the engine to
prevent unintended starting.
Positioning the Upper
Handle
pivot the upper handle into the operating position as
illustrated in Figure 3-1 until it clicks into place.
as in Figure 3-1.
Assembling the
Chute assembly
straight ahead. Remove the star knob and carriage
bolt from the lower chute. See Figure 3-2.
chute so that there is NO gap between the upper
chute and the lower chute.
correctly, your snow thrower should look like Figure
3-3.

Advertisement

Table of Contents
loading

This manual is also suitable for:

9235S235

Table of Contents