Owlet Home J1 Quick Start Manual
Hide thumbs
Also See for J1:
- Quick start manual (11 pages) ,
- Quick start manual (13 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Owlet Home J1
Summary of Contents for Owlet Home J1
- Page 2 1. What’s in the box Please consult below checklist for all the components. Video Doorbell USB Cable User Guide Screws & Tools Batteries Double-sided Tape 2. Meet the doorbell 2MP Camera Doorbell Button Reset Hole PIR Motion Sensor Microphone Hardwire Power Port Speakers Charging Indicator SD Card Slot...
-
Page 3: Battery Installation
3. Battery installation The batteries are pre-installed into the doorbell. If you had taken out the batties somehow, please note the electrodes when install them back. Do put the positive poles upward! Note: Improper battery installation will cause damage to the internal components and may result in serious injury. -
Page 4: App Download
5. App download Download and install the ' CloudEdge ' app from Google Play the App Store The app is also available by scanning below QR codes, using your QR code scanner in your smart phone. CloudEdge Android Note: Andriod is a trademark of Google Inc. -
Page 5: Live View Interface
7. Run a test After setup, tap on the live view window in the app for a test. Then take your doorbell outside to the installation spot and run a test there. Make sure the installation spot is covered by strong 2.4 GHz Wi-Fi signal. Note: If the video quality from the doorbell outside is not as good... - Page 6 9. leave a Voice message You can leave a max 30 seconds voice message on the on-board memory of your doorbell, so as to quickly respond your visitor by a tap on your phone when you are out and occupied. It can be done even without an Micro-SD card.
- Page 7 mount your doorbell 1. Take out the wall mount by 2. Mark the screw positions to pushing from its back. mount the bracket. Tape Tape 3. Drive the screws into the 4. (Optional) You can also use the anchors, or directly into your wall double-sided tape we provided until the bracket is tightly fastened instead of screws.
-
Page 8: Key Features
11. Key features Remote view & control The devic will be sleep to save power, and can be activated remotly from your CloudEdge app to view and control. Full-duplex audio The device support 2-way audio intercomm. You can see, hear and speak to your visitor even when you are not home. -
Page 9: Specification
12. Specification Video & Audio Image Sensor 1/2.7” CMOS (2.0MP) Hisilicon Lite-OS Effective Pixels 1920 × 1080 px Stream HD/SD dual stream Infrared LED High power IR LED with ICR Lens 1.7mm/F2.0 Angle of View 140° Min. Illuminance Color: 0.01 Lux; B&W: 0.001Lux Digital WDR Audio Two-way audio with noise cancellation... -
Page 10: Troubleshooting
Trouble shooting Q1: Why I failed to set up Wi-Fi for the doorbell? A1: ①.Device works with 2.4GHz Wi-Fi only, but not support 5GHz Wi-Fi. ②.Wi-Fi network is not good, try to keep the camera near the Wi-Fi router when setting up. ③.The Wi-Fi password is wrong. Please check if there are special characters in the password, or the network is specially encrypted.
Need help?
Do you have a question about the J1 and is the answer not in the manual?
Questions and answers