Other Operating Instructions; For A Rinse And Spin; For A Drain And Spin; Cleaning The Lint Filter - Whirlpool LASOOXP Use And Care Manual

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse 1
l
Push Control Knob In
l
Turn clockwise to anyoon the dial
See above drawing.
l
Pull Control Knob out.
. The washer will fill to selected level
with cold water, agitate 2
minUteS.
drain and spin.
For a soak or pre-wash
For a drain and spin
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
l
Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out
l
The washer will drain and spin.
For agitation and spin speeds in each
cycle, see pages 6 and 7.
l
Use enough detergent or pre-soak
product for a single load.
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the SOAK Cycle.
l
Pull Control Knob out.
. When the cycle is over, add de-
tergent for the next selected wash
cycle. Important: See additional
care information on page 7 of your
for best results, use warm
Water
"laundry Guide!'
for soaking or pre-washing stained
l
Set the washer and start the next
laundry. selected wash cycle.
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of lint build-up.
l
Lift off the agitator barrel.
l
Rinse or wipe the filter clean in the
bottom of the agitator barrel. The
filter is not removable.
l
Replace the agitator barrel and
8
snap into place.