Liquid Fabric Softener Dispenser; For Rinsing Only - Whirlpool LA6400XK Use And Care Manual

Liquid Fabric
Softener Dispenser
The dispenser for llquld fabric
softener fits over the, top of the agitator
The dispenser
WIII k 31d
enough
diluted
fabric softener for one deep rinse
l
After adding the jetergeni and the
load, fii the dlspen;er over the top of the
agitator cap
Full Mark
l
FolIowIng directions on the bottle,
add the correct arr>ouni of fabric soft-
ener Use a cup with a pouring spout
to avold dripping any on the load
l
IMPOf?TANT: Add enough hot or
warm water to fill the dispenser to
the FULL mark.
l
Diluted fabric softener ~111 be added
just before the washer starts filling for the
rinse.
NOTE:
Do not stop the washer
during
the first spin (when the wash
water IS spinning out] If you do, the fab-
rlc softener WIII be added to the wet,
soapy load This can cause stains
l
Clean the dispenser after each use
with warm
wafer only.
Detergent can
make softeners sticky and lumpy.
For a Pre Wash
Use this setting for a shorter SOAK
CYCLE (no rinse). Use enough detergent
for a single wash. Add the load
l
Set the
LOAD SIZE SELECTOR.
l
Set wash water temperature.
l
Push the Cycle Control Knob in and
turn it to the 12-minute mark in the SOAK
CYCLE
l
Pull the Control Knob out to start ihe
washer
l
'he washer WII! fill, agitcte fo7 "AC
minutes, soak for eight mlrJtes 7Jl+ate
for two more, and trien drai? cr'j spir
[See SOAK CYCLE descrlD+ior- 3' unge
10 )
l
After filling, the washer may pause
before starting to agitate.
For Rinsing Only
Your washer can be set to rinse
only Use the setting for an extra rinse or
for laundry that only needs a rirse ard
spin
PERMANENT
PRESS
There is a doi just after the num-
bers in PERMANENT PRESS, REGULAR
HEAVY and KNITS GENTLE If YOU push lr
on the Cycle Control Knob, turn the
pointer to one of those dots and pull the
Control Knob out, the washer iz/lli fill,
agitate, drain and spin.
If you want high agitation and
spin. use the dot In REGULAR HEAVY If
you want low agitation and spin, use ihe
dot in KNITS GENTLE Use the dot in PER-
MANENT PRESS if you want high
agltatlon and a low-speed spin
For Spinning Only
To set the washer so it drains and
spins water out of the load, push in or'
the Control Knob, turn the dial to the
right (clockwlse) so the pointer IS touchy
ing the bar just before OFF in any cycle
REGULAR
The washer will drain, spin out
water and stop If you want a low-spee
spin, use the bar on PERMANENT PRESS
or KNITS GENTLE, All the other cycle
settings have a high-speed spin.