Laser Overview; Specifications; Product View And Parts Identification - Banner QS30 Series Manual

QS30 Series Diffuse-Mode Laser Sensor
The QS30 is an easy-to-use, high-performance laser sensor whose many
configuration options make it suitable for demanding applications. It provides
high-performance sensing in low-contrast applications at relatively long range. It
features static, dynamic and single-point TEACH-mode programming, in addition
to manual fine adjustment, remote programming and security lockout options. A
SETUP mode also may be used to change the sensor's output response
(see page 8).
The sensor features two identically configured outputs, one each NPN and PNP.
The sensor's compact housing has a large, easy-to-see bar graph display plus
bright LEDs for easy programming and status monitoring during operation. The
sensor can be side-mounted, using its integral mounting holes, or front-
mounted, via its 30 mm threaded barrel.
Sensing Beam
Beam Size at Aperture
Laser Classification
Supply Voltage
Supply Protection Circuitry
Delay at Power Up
Output Configuration
Output Rating
Output Protection
Output Response Time
Repeatability
Adjustments
Indicators
Construction
Environmental Rating
Connections
Operating Temperature
Vibration and Mechanical Shock
Certifications
2
P/N 109027 rev. C
QS30 Laser Overview
QS30 Laser Specifications
Class 1: 650 nm visible red
Class 2: 658 nm visible red
Approx. 2 mm
Class 1 or Class 2, depending on model (see page 3)
10 to 30V dc (10% max. ripple @ 10% duty cycle) @ 35 mA max current, exclusive of load
Protected against reverse polarity, over voltage, and transient voltages
1 second max.; outputs do not conduct during this time
Bipolar: 1 current sourcing (PNP) and 1 current sinking (NPN)
150 mA maximum load
OFF-state leakage current: < 10 µA at 30V dc
ON-state saturation voltage:
NPN: < 1.0V @ 150 mA load
PNP: < 2.0V @ 150 mA load
Protected against output short-circuit, continuous overload, transient over-voltages, and false pulse on power up
500 microseconds
70 microseconds
2 push buttons and remote wire
• Expert Teach programming (two-point static, dynamic, and single-point static)
• Manually adjust (+/–) thresholds (from buttons only)
• LO/DO and OFF-delay configuration options
• Push-button lockout (from remote wire only)
8-segment red bargraph: Signal strength relative to switch-point
Green LED: Power ON
Yellow LED: Output conducting
ABS plastic housing; acrylic lens cover
IP67, NEMA 6
5-conductor 2 m (6.5') PVC cable, 9 m (30') PVC cable, or 5-pin integral Euro-style quick-disconnect fitting
-10° to +50°C, 90% relative humidity @ 50°C (non-condensing)
All models meet Mil. Std. 202F requirements. Method 201A (Vibration: 10 to 60Hz max. double amplitude 0.06",
maximum acceleration 10G). Also meets IEC 947-5-2 requirements: 30G, 11 ms duration, half sine wave.
Yellow Output Conducting
Indicator
Green Power ON
Indicator
Bargraph
Display
Switching
Threshold
SETUP Status
Indicators:
Delay
Dark Operate
Light Operate
Figure 1. QS30 features
Banner Engineering Corp. Banner Engineering Corp. Minneapolis, MN U.S.A. Minneapolis, MN U.S.A.
• •
www.bannerengineering.com • Tel: 763.544.3164 www.bannerengineering.com • Tel: 763.544.3164
Programming
Push
Buttons