Starting Or Stopping Your Washer; Selecting A Load Size - Whirlpool LBR5133AG0 Use & Care Manual

OperatingYour Washer
I
In This Section
Before starting your washer ............................. .5
Starting or stopping
your washer
.................... .5
Selecting a load size ......................................... .5
Selecting wash+inse temperatures ................ .6
Page
Selecting a cycle and time ............................. .6
Using rinse and apin .......................................
.8
Using drain and spin ......................................
.6
What happens
in each cycle .......................... .Q
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted NOTE:
If your washer has a Consumer Buy
load in the washer before starting. See page 11
Guide, remove it and place it in your Use and
for additional "Before you wash" information.
Care Guide.
Starting or stopping your washer
Starting your washer:
1. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob's outer ring points to the number in the
wash cycle you want. The numbers are
minutes of wash time. Make other selec-
tions, if necessary.
2. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopplng and restarting your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
l
To restart the washer, close the lid (if neces-
sarv1 and
DUII
out the Cvcle Control Knob.
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash.
Select a load size based upon the size of the
load and the fabric you are washing. See
page 11 for additional loading information.
5