greenhouse sensation click&drip P00GS48A Instructions

Water Timer
Instructions
Model Number: P00GS48A

Timer Features

⑩
③
④
⑨
⑤
⑧
⑦
Battery compartment & Battery compartment cover
1 2
Slide out the battery compartment
2x (LR03/AAA) 1.5V alkaline batteries.
WARNING
A. Use only fresh alkaline batteries at the beginning
of the season. DO NOT use rechargeable batteries.
B. Test the unit by turning the Run Time knob to ON
position. You should hear the sound of the motor
within 10 seconds. If you do not hear the sound,
check if the batteries are installed correctly.
C. Turn Run Time to OFF position before connecting
to tap.
3/4" Tap adaptor and Collar ring.
3 4
Turn the collar ring loose until the tap adaptor
4
unlocked, screw the tap adaptor
and then lock them tight with the collar ring
WARNING
DO NOT use spanners or pliers to avoid damage
to the timer.
Frequency knob
5
Determine how often you will water, from 1 hour to 1 week.
Run Time knob
6
Choose how long to water, from 1 minute to 120 minutes.
Male snap-on connector
7
Connect hose attachment to the male snap-on connector
at the bottom of the timer.
⑥
7
Delay button
8
To delay the start watering time press Delay button for
more than 3 seconds until led is constantly ON, then
each press of delay button means 1 hour delay of the
①
next start watering time (EXAMPLE 3).
Led indicator
9
②
Led indicator flashes once every 4 seconds.
WARNING
Replace with new batteries if led indicator flashes quickly
or continually on.
, and insert
1
Filter
10
Filter traps dirt particles and prolong life of timer.
WARNING
Clean filter regularly and replace if worn.

PROGRAM TIMER

1. Set Frequency (determine how often you will water,
from 1 hour to 1 week.)
2. Set Run Time (determine how long to water,
from 1 minute to 120 minutes.)
NOTE: The first watering will start X hours later, X is the
set frequency hours.
is
3
WARNING
on to the tap tight
3
Frequency should always be longer than Run Time.
.
4
(Example: Frequency=1H, Run Time=90 minutes,
is NOT a valid setting.)