Download  Print this page

Make Electrical Power Supply Connection To Hood Liner - KitchenAid 36" Installation Instructions And Use And Care Manual

36" (91.4 cm) and 48" (121.9 cm) hood liner
Hide thumbs

Advertisement

WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
8. Connect the green (or yellow/green) ground wire to the
green/yellow ground wire (H) in the terminal box using UL
listed wire connectors.
9. Reinstall the in-line blower terminal box cover and screw.
10. Reinstall the front cover of the in-line blower housing and
secure it with 10 mounting screws.
Electrical Connection Inside Hood Liner Between In-line
Blower System and Hood Liner
1. With the hood liner mounted (see the "Install Hood Liner"
section), locate the wiring cable connector inside the hood
liner.
2. Connect the 6-wire connector assembly supplied with the
in-line blower motor system to the mating cable connector
from the hood liner.
3. Locate the terminal box inside the hood liner and install a
" (1.3 cm) UL listed or CSA approved strain relief (see
"Complete Preparation" in the "Prepare Location" section).
4. Run the wire ends from the 6-wire connector assembly
through the
" (1.3 cm) strain relief, leaving enough wire
length to make the wiring connections. Tighten the strain
relief screws.
5. Connect the wires from the 6-wire connector assembly to the
wires from the wiring conduit inside the hood liner terminal
box.
6. Connect the same color wires to each other (black to black,
white to white, etc.) using UL listed wire connectors.
12
NOTE: Connect the green (or green/yellow) ground wire from
the wiring conduit to the green (or bare) ground wire from the
home power supply using UL listed wire connectors (see the

"Make Electrical Power Supply Connection to Hood Liner"

section).
B
A
A. UL listed or CSA approved
" (1.3 cm) wiring conduit
B. UL listed wire connectors
C. Black wires
D. White wires
E. Red wires
7. Go to the "Make Electrical Power Supply Connection to Hood
Liner" section.
Make Electrical Power Supply Connection
to Hood Liner
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Locate terminal box inside of the hood liner.
A
A. Terminal box cover
B. Terminal box
C
D
E
F
G
H
I
F. Blue wires
G. Gray wires
H. Green (or green/yellow)
wire
I. 6-wire connector assembly
B

Advertisement

Table of Contents
loading

  Related Manuals for KitchenAid 36"