Panasonic CF-VDR Series Operating Instructions Manual page 19

Placing and Removing Discs
This drive's disc cover is designed to be opened electrically. When power is not supplied to
the drive, the disc cover will not open even when the open button is pressed.
3
2
4
Title-side up
CAUTION
•
Set the disc correctly. Otherwise, it may spin off and be damaged as a result.
•
If power is not supplied to the drive, slide the emergency open lever.
( page 8 (D)).
•
If you want to remove discs when a program is being used, exit the program, and check
that the drive's indicator does not light up in orange.
NOTE
•
Since the disc cover is locked while a B's CLiP formatted disc is being used, click
[Eject] from the icon displayed on the notifi cation area to release the lock.
•
While data is being written, the indicator lights up and the disc cover is locked:
therefore, the disc cover cannot be opened during data writing.
1 Turn on the drive's power.
The drive's on/off power operations are
coupled to the computer so that when the
computer is turned on or off, the drive
will be automatically turned on or off.
2 Press the open button.
The disc cover opens slightly.
(The disc cover can also be opened by
selecting [Eject] from the application
software.)
3 Open the disc cover fully.
4 Insert the disc.
Use your fi ngers to press the part near
the disc center down until the disc is
secured in place.
<Removing the disc>
Check that the disc has stopped turning
completely, and remove it by pressing
down on its center part while clasping its
outer edge and lifting it free.
5 Close the disc cover.
19