Transportation; Storage; Technical Data - Husqvarna 130 Mark II Operator's Manual

To lubricate the cutting equipment
To do a check of the saw chain lubrication
Do a check of the chain saw lubrication each time you
refuel.
1. Start the product and let it run at 3/4 speed. Point the
nose of the guide bar at a light color surface almost
20 cm (8 in) away.
2. After 1 minute of running, a line of oil shows on the
light surface.
3. If you cannot see the line of oil after 1 minute, clean
the oil channel in the guide bar. Clean the groove in
• Empty the fuel and chain oil tanks before
transportation. Discard used fluids correctly.
• Put the guide bar cover on the cutting attachment
during transportation. This prevents persons from
touching the sharp saw chain by accident. A saw
chain not in operation can cause injury to you or
other persons that touch a sharp saw chain.
• Always put the product away safely when not in
operation. Leakages and fumes from the product can
touch sparks, naked flames from electrical
equipment, electrical mowers, relays/switches,
boilers and more.
• Always save fuel in an approved container.
• Empty the fuel and chain oil tanks when the product
is in storage for longer periods of time. Discard used
fluids correctly.
Engine specifications
Cylinder displacement
Spark plug
Electrode gap
Fuel tank volume
Idling speed
Power output at 9000 min
Emission durability period
Noise and vibration data
862 - 001 - 20.09.2018

TRANSPORTATION

STORAGE

TECHNICAL DATA

-1
the edge of the guide bar. Make sure the guide bar
nose sprocket turns freely and that there are no
blockages in the lubrication hole. Clean and lubricate
the tip sprocket.
4. Start the product and let it run at 3/4 speed. Point the
nose of the bar at a light color surface almost 20 cm
(8 in) away.
5. After 1 minute of running, a line of oil shows on the
light surface.
6. If you cannot see the line of oil after 1 minute, speak
to your approved dealer.
• Remove the spark plug cap from the spark plug and
engage the chain brake before transportation.
• Make sure the product cannot move during
transportation.
• During storage, put the guide bar cover on the guide
bar. This prevents persons from accidentally
touching the sharp saw chain. A saw chain not in
operation can cause serious injury to you or persons
who touch a sharp saw chain.
• Remove the spark plug cap from the spark plug and
engage the chain brake before storage.
unit 130 (H13038HV)
3
cm 38
— NGK BPMR 7A
mm (in) 0.5 (0.02)
3
cm 350
-1
min 2800-3200
kW 1.5
h 125
135 Mark II
(H13038HV)
38
NGK BPMR 7A
0.5 (0.02)
350
2800-3200
1.6
125
21