Whirlpool TS22BR Use And Care Manual page 17

PART
WHAT TO USE HOW TO CLEAN
Defrost pan
Sponge or cloth with
mild detergent and
warm water
l
Remove base grille. (See page 14.)
l
To remove defrost pan, lift pan over wire brace
(remove tape; if any).
. Wash, rinse and dry thoroughly.
l
Replace with notched corner to the rear. Push it
in all the way.
. Make sure defrost pan drain tube is pointing
into pan.
l
Replace base grille.
Condenser coils
Vacuum cleaner with
extended narrow
attachment
l
Remove base grille.
l
Vacuum coils when dusty or dirty. Coils may
need to be cleaned as often as every other
month.
l
Replace base grille.
Floor under
refrigerator
Floor cleaners
l
Roll refrigerator out away from the wall.
l
Clean floor.
l
Roll refrigerator back into place.
. Check to see if the refrigerator is level.
Vacation and moving care
Long vacations
Remove all the food if you are going for a month
or more. Turn off the water supply to the ice
maker at least one day ahead. When the last
load of ice drops, turn off the ice maker. Make
sure all ice is dispensed out of mechanism.
Unplug the refrigerator. Clean it, rinse well and
dry. Tape rubber or wood blocks to the tops of
both doors to prop them open far enough for air
to get in. This will keep odor and mold from
building up.
Personal Injury Hazard
Do not allow children to climb on, play near
or climb inside the refrigerator when the
doors are blocked open.
They may become injured or trapped.
To restart refrigerator, see "Using Your Refrigera-
tor" on page 7.
No need to shut off the refrigerator if you will be
Short vacations
away for less than four weeks. Use up perish-
ables; freeze other items. Then:
1. Turn off your ice maker by raising signal arm.
2. Shut off the water supply to the ice maker.
3. Empty the ice bin.
Moving
Shut off the ice maker water supply at least a day
ahead. Disconnect the water line. After the last
load of ice drops, lift the signal arm to turn off the
ice maker.
Remove all food. Pack frozen food in dry ice.
Unplug the refrigerator and clean it thoroughly.
Take out all removable parts. Wrap all parts
well and tape them together so they don't shift
and rattle. Screw in the leveling legs; tape the
doors shut; and tape the electric cord to the
cabinet.
When you get to your new home, put every-
thing back and refer to page 5. Also, remember to
reconnect the water supply line.
17