Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET1NK Use & Care Manual

Install properly.. .
1 Allow 3 ,nches (7 5 cm) between overhead cabl-
nets and refrigerator top
2 Allow at least an Inch (2 5 cm) between the
refrigerator condenser on the back and the wall
3 Allow : Inch (1 25 cm) on each srde of the
refrigerator for ease of lnstallatron
4 If the refngerator IS to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wrder
Level refrigerator-freezer.. .
Levelling Leg
Raise Lower
This refrigerator has 2 threaded levelling legs that are
shipped in a separate package
I. Screw these legs all the
way
into bolt holes in the
bottom front corners of refrigerator
2. Roll the refrigerator into place.
3. Lower legs just enough to M-t front rollers off floor
4. Adjust front legs to level the refrigerator
- To raise corners, turn legs in direction
shown.
- To lower corners, turn legs In directron
shown.
5. Check with level.
Remove sales labels . . .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1 Rub briskly with thumb to make
a
ball then remove
OR
2 Soak area with dishwashing detergent solution (I
teaspoon detergent in 1 quart warm water] before
removing glue as descrrbed In step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refrigerator
before usrna It.
See cleaning rnstructions ":
on page 8
Plug it in...
&prong grounding
type wall receptacle,
111~ ,
II I
3-prong
grounding plug
t
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrlcal supply IS re-
quired It IS recommended that a separate clrcurt
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See tndtvrdual electrlcal requtre-
ments and grounding Instructron sheet In your Ilter-
ature package