After Installation - Valor LINEAR Series Installation Manual

After Installation

Resetting the Module
In the event of a nonrecoverable failure, or if the
homeowner needs to set up a new home network, the
WiFi module can be easily reset to factory default to
allow all the setup steps to be done again.
Caution
Performing this action removes all network data
from your WiFi module!
To reset the module:
1. Ensure it is receiving power from the fi replace.
2. Insert a thin object (eg. paper clip) in the small
opening below the WLAN LED on the unit and press
until you feel the reset button click.
Reset button
3. Hold the reset button for 20 seconds.
During the reset, the Receiver LED will blink blue slowly,
then quickly. After the full 20 seconds, it will blink blue
slowly again, and you can release the button. The
Receiver LED will turn solid green.
Upon reset, the WLAN will briefl y blink red (to indicate
network loss) and then blink blue (to indicate seeking a
connection).
The module is now at factory default and you are
ready to confi gure per the instructions in For Software
Information (see below).
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
Designed and Manufactured by / for
Miles Industries Ltd.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
www.valorfi replaces.com
For Software
Information
For information on how to
use the Valor 10 software
app to confi gure and
operate your upgraded
fi replace, please see "Valor
10 WiFi Control Software
Instructions", document
4007972.
7