Whirlpool 2183013 Use And Care Manual page 12

Connecting to water line
1.
Find a %-inch to 1 V&inch vertical COLD
Vertical cold
water plpe
%lnch O.D.
water pipe near the refrigerator.
NOTE:
Horizontal pipe will work, but the
following precaution must be taken: Drill
on the top side of the pipe, not the
bottom. This will help keep water away
from the drill. This also keeps normal
sediment from collecting in the valve.
2. Measure from connection on rear of
refrigerator to water pipe. Add 7 feet
(2.1 m) to allow for moving refrigerator for
cleaning. This is the length of X-inch O.D.
copper tubing you will need for the job
(length from connection to water pipe
PLUS 7 feet (2.1 ml). Be sure both ends of
copper tubing are cut square.
3. Turn OFF main water supply. Turn ON
nearest faucet long enough to clear line
of water.
Inlet on rear of
Compresslon nut
TO REFRIGERATOR +
*Controls water supply
4. Using a grounded drill, drill a X-inch hole
on the cold water pipe you have selected.
5. Fasten shut-off valve to cold water pipe
with pipe clamp. Be sure outlet end is sol-
idly in the X-inch drilled hole in the water
pipe and that washer is under the pipe
clamp. Tighten packing nut. Tighten the
pipe clamp screws carefully and evenly
so washer makes a watertight seal. Do
not overtighten or you may crush the
copper tubing, especially if soft (coiled)
copper tubing is used. Now you are ready
to connect the copper tubing.
6. Slip compression sleeve and compres-
sion nut on copper tubing as shown in
diagram. Insert end of tubing into outlet
end squarely as far as it will go. Screw
compression nut onto outlet end with
adjustable wrench. Do not over tighten.
Turn ON main water supply and flush out
tubing until water is clear. Turn OFF shut-
off valve on the water pipe. Coil copper
tubing.
12
WITH QUESTIONS OR COMMENTS