Download  Print this page

Oven Use; Electronic Oven Controls; Aluminum Foil - Whirlpool W10204320B User Instructions

Whirlpool gas range use and care guide
Hide thumbs

Advertisement

3. Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden toothpick.
If the burner needs to be adjusted, contact a trained repair
specialist.
Odors and smoke are normal when the oven is used the first few
times, or when it is heavily soiled.
Control Display
The display will flash when powered up or after a power loss. Press
CANCEL/OFF to clear. When oven is not in use the time of day is
displayed. Indicator lights show functions that are in use.
Tones
Tones are audible signals, indicating the following:
Basic Functions
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder (on some models), repeating each minute after the
end-of-cycle tones
Three tones
Invalid pad press
Four tones
End of cycle
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To change: Press and hold BROIL for 5 seconds. A tone will
sound, and "°C" or "°F" will appear on the display. Repeat to
change back.
To exit mode, press CANCEL/OFF.
IMPORTANT: To avoid permanent damage to the oven bottom
finish, do not line the oven bottom with any type of foil, liners or
cookware.
6
4. Replace the burner cap, making sure the alignment pins are
properly aligned with the burner cap.
5. Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.

OVEN USE

IMPORTANT: The health of some birds is extremely sensitive to the
fumes given off. Exposure to the fumes may result in death to
certain birds. Always move birds to another closed and well-
ventilated room.

Electronic Oven Controls

Oven Temperature Control
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door may cause element
cycling to give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
To Adjust Oven Temperature Calibration:
1. Press and hold BAKE for 5 seconds until the oven display
shows the current calibration, for example "0°F CAL" or "00."
2. Press the TEMP/TIME "+" or "-" arrow pads to increase or to
decrease the temperature in 10°F (5°C) amounts. The
adjustment can be set between 30°F (15°C) and -30°F (-15°C).
3. Press START.
Options Mode
Press and hold TIMER for 5 seconds, and "Opt" will appear. Use
the TEMP/TIME keys to cycle through the following options. Press
CANCEL to exit the mode.
End of Cycle Tones
"b1" (beep once) or "b" (continue to beep) will be displayed. Press
TIMER to toggle through selection.
12-Hour Shutoff
If "12 Hr" is displayed, the oven will automatically shut off after
12 hours. Press TIMER to toggle to "- Hr" to disable the 12-hour
shutoff.
Oven Light with Door Open
"LOn" indicates that the oven light will turn on when the door is
open. If "LOFF" is displayed, the oven light will turn on only with the
oven light switch. Press TIMER to toggle through selection.

Aluminum Foil

For best cooking results, do not cover entire oven rack with foil
because air must be able to move freely.
A
B
A. Incorrect
B. Correct

Advertisement

Table of Contents
loading

  Related Manuals for Whirlpool W10204320B

This manual is also suitable for:

W10204511a