Oven Door; Storage Drawer - Whirlpool W10162215A Use And Care Manual

Solution of ¹ ₂ cup (125 mL) ammonia to 1 gal. (3.75 L) water:
■
Soak for 20 minutes, then scrub with scouring or steel-wool
pad.
■ Oven cleaner: Follow product label instructions.
Porcelain enamel only, not chrome
■ Dishwasher
STORAGE DRAWER (on some models)
Make sure drawer is cool and empty before cleaning.
For more information, see "Storage Drawer" section.
Cleaning Method:
■ Mild detergent
Drawer Liner (on some models)
Remove all stored items from drawer and lift out drawer liner.
■ Clean with mild detergent
■ All-Purpose Appliance Cleaner Part Number 31662 (not
included):
See "Assistance or Service" section to order.
WARMING DRAWER and TRAY (on some models)
Make sure drawer is cool and remove tray.
Cleaning Method:
■
Mild detergent (for both)
■ All-Purpose Appliance Cleaner Part Number 31662 (not
included):
See "Assistance or Service" section to order.

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.

Storage Drawer

The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull the storage drawer straight back past the drawer stop
notch and the end of the side rails.
A. Drawer stop notch
B. End of side rail
2. Lift up the back of the drawer and pull the drawer out.
To Replace:
1. Lift up the back of the drawer and place it inside the range in
its fully forward position.
2. Lift up the front of the drawer to a level position.
3. Slowly push the drawer into the range until the drawer side
rails engage with the gap in the drawer glides.
A. Engage drawer glide.
4. Once the drawer is fully engaged on both sides, slide the
drawer back into the closed position.
NOTE: When you are removing and replacing the storage
drawer, a slight push may be needed to move the drawer
stop notch past the drawer glides.
B
A
A
13