8
Chapter
8.1. Camcorder Settings
For camera remote operation via a network, set Maintenance > Wi-Fi Settings > Wi-Fi Remote in the setup
menu to Enable.
This function is available only on Network RX Station.
8.2. Camera Remote Test
After checking that Network Client Mode communication is successful, you can check camera remote
operation.
This test is controlled from the CCM UI.
1
Select a camcorder and set the Network Range and the destination receiver (Network RX Station).
2
Issue the Start command for QoS streaming from the CCM.
The camcorder starts streaming.
When streaming is successful, the STRM icon appears on the LCD screen and the streaming picture
appears in the CCM UI preview area.
If you experience any difficulty, see
3
Select the Remote tab on the CCM UI screen.
4
Check that the CCM can control camera zoom, iris, focus, etc.
If you experience any difficulty, see
Setup for "Camera Remote Control"
"12.3.1. Live Streaming"
"12.3.2. Camera Remote Control"
in the Troubleshooting section.
in the Troubleshooting section.
37