Whirlpool TER56W2B Use And Care Manual page 43

PROBLEM
Self-Cleaning
cycle will not
operate
POSSIBLE CAUSE
SOLUTION
The Oven Selector and Oven
Set both the Oven Selector and Oven
Temperature Control Knob
Temperature Control Knob to CLEAN.
are not set to CLEAN.
The range clock does not
Reset clock to show the correct time
show the correct time of day.
of day. (See page 12.)
The Lock Lever is not in the Move Lock Lever all the way to the
CLEAN position-all the way
right.
to the right.
A delayed start time has been Wait for the start time to be reached.
programmed.
Cooking
The range is not level.
Level range. (See Installation Instruc-
results are not
tions.)
what you
expected
The oven temperature is too See page 15 for instructions on how
low or too high. to adjust the Oven Temperature
Control.
The oven was not preheated Preheat oven when called for in
before baking. recipe.
The recipe has never been Use only tested recipes from a
tested or is not from a reliable reliable source.
source.
The pan used is not the type
or size recommended in the
recipe.
Refer to a reliable cookbook for
recommended pan type and size.
There is not proper air
circulation around pan when
baking.
Allow 1% to 2 inches (4-5 cm) of air
space on all sides of pan. There must
be a minimum space of 1 inch
(2.5 cm).
Cooking utensil does not fit
the surface unit being used.
Pan should be the same size or
slightly larger than surface unit being
used.
The display is
flashing
"88:88"
There has been a power
failure.
Reset the clock. (See page 12.)
"F2" shows in Call for service. (See Step 3 on
the display page 44.)
43