Drying Cabinet Door Swing Dimensions
Minimum installation spacing for custom cabinetry or trim
The dimensions shown following are for the minimum spacing
Additional spacing should be considered for ease of
installation and servicing.
Additional clearances might be required for wall, door and
For built-in installation, minimum ventilation openings in the
top are required.
12" (30.5 cm) min.
1. Front view
2. Side view
3. Open to the outside of the enclosure for
airflow (see "Venting Requirements")
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
It is your responsibility
To contact a qualified electrical installer if an electrical outlet
is not currently available.
To be sure that the electrical connection is adequate and in
conformance with the National Electrical Code, ANSI/NFPA
70-latest edition and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association, Batterymarch Park,
Quincy, MA 02269.
To properly install your drying cabinet, you must determine the
type of electrical connection you will be using and follow the
instructions provided for it here.
The drying cabinet should be connected to a 120 V 60 Hz
3 prong grounded outlet.
The drying cabinet is ready for connection with a 5 ft.
(152.4 cm) long cable with a grounded plug. Use only the
supplied cable and plug.
The outlet should be located for easy plug removal.
If using a replacement power supply cord, it is recommended
that you use Power Supply Cord Replacement Part Number
8181928. For further information, please call the Customer
Interaction Center at 1-800-253-1301. In Canada, call