Troubleshooting Of Minor Faults - Bosch WFMC 4300UC Operation & Care Instructions Manual

Troubleshooting of Minor Faults

d
WARNING
Fault
The door cannot be
opened.
Door cannot be opened,
even though the
appliance has been
switched off and on
again.
Control lights do not light g g
up. p
Program does not start.
Start/Pause indicator
light flashes.
Program does not start.
Indicator light end" is lit Indicator light end" is lit
and display is flashing
E:01"
Spin speed cannot be
selected.
Water does not enter the
machine or detergent is
not washed away. t h d
Indicator light spin" is lit Indicator light spin" is lit
and display is flashing and display is flashing
E:02" or E:03".
d
q
Off
q
q
q
Possible cause
No final spin" selected.
Power failure.
Program is running and/or the door is locked for
safety reasons.
Plug is loose or not inserted.
Program selector turned to Off before end of
program.
For safety reasons the door has been locked because
the water level, temperature or speed is too high.
A fuse has blown.
Power failure.
Start/Pause button not pressed.
Door not closed properly.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Water tap(s) not turned on.
Supply hose kinked or pinched.
Strainers in supply hose clogged.
Water pressure too low.
Action
Select Drain or Spin.
An interrupted program will be resumed when power
is restored. If the laundry is to be removed during
a power failure, Customer Service
(refer to Page 27).
Wait until the program ends; see Page 22.
Eliminate the cause.
Select a program.
See "Add a garment/Interrupting the program",
Page 22.
Replace the fuse of the individual circuit.
Call Customer Service if this fault recurs.
An interrupted program will be resumed when power
is restored. If the laundry is to be removed during a
power failure, Customer Service
(refer to Page 27).
Press the Start/Pause button.
Check whether laundry is trapped in door.
Close the door (a click should be heard).
Program continues.
Select speed before spinning.
Turn on water tap(s) and press Start/Pause button.
Program continues.
Eliminate the cause.
Clean the water inlet strainers; see Page 23.
Eliminate the cause.
25