Panasonic CS-Z20TKR Service Manual page 147

18.1.1.3 To Remove Electronic Controller
5. Detach the terminal wire (Black),
terminal wire (Red) and earth wire screws.
8. Remove screw to remove
terminal board complete.
7. Detach CN-DISP and CN-RCV
connectors from indicator complete.
Figure 3
Figure 2
9. Pull out the
10. Detach all connectors as labelled from the
electronic
controller halfway.
6. Detach the terminal
wire CN2 (Black),
terminal wire
GND (Green) and
connector CN1
then remove the
high voltage
generator.
147
3 Hooks (Top, left
and right hand side)
4. Remove control board
cover by releasing 3 hooks.
electronic controller. Then pull out the
electronic controller gently.
CN-TH
Figure 4
AC303 (WHT)
CN-FM
CN-STM1
CN-STM2
CN-STM3
CN-CLN
CN-MSENS