Electrical Safety - Black & Decker KD750 Instruction Manual

When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly using
power tools in employment, an estimation of
vibration exposure should consider, the actual
conditions of use and the way the tool is used,
including taking account of all parts of the
operating cycle such as the times when the tool
is switched off and when it is running idle in
addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury,
the user must read the instruction
manual.

Electrical safety

This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to
the voltage on the rating plate.
•
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Lock-on button
3. Forward/reverse switch
4. Drilling mode selector
5. Tool holder
6. Side handle
7. Depth stop
8. Depth stop lock button
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting the side handle (fig. C)
•
Turn the grip counterclockwise until you can
slide the side handle (6) onto the front of the
tool.
•
Rotate the side handle into the desired
position.
•
Tighten the side handle by turning the grip
clockwise.
Fitting an accessory (fig. A)
•
Clean and grease the shank (9) of the
accessory.
•
Pull back the sleeve (10) and insert the shank
into the tool holder (5).
•
Push the accessory down and turn it slightly
until it fits into the slots.
•
Pull on the accessory to check if it is properly
locked. The hammering function requires the
accessory to be able to move axially several
centimetres when locked in the tool holder.
•
To remove the accessory, pull back the
sleeve (10) and pull out the accessory.
Use
Warning! Let the tool work at its own pace. Do
not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
ENGLISH
7