Advertisement
F
PROBLEM
Burner
flames are
uneven
POSSIBLE
CAUSE
Burner ports are clogged.
SOLUTION
Clean with a straight pin (see pages
17 and 21). If this fails, call an
authorized Whirlpool service
technician for service.
Burner
Air/gas mixture is incorrect.
Contact an authorized Whirlpool
flames lift off
service technician to check air/gas
ports, are
mixture.
yellow,
or
are noisy
when turned
Off
Burner makes
Burner is wet from washing.
Let dry.
popping
noise
when on
Control
knob(s) will
not turn
You are not pushing in before
Push control knob(s) in before
turning.
turning to a setting.
Cooking
The range is not level.
Level range. (See Installation
results are
Instructions.)
not what you
expected
The oven temperature seems
Adjust the oven temperature control.
too low or too high.
(See "Adjusting the oven temperature
control" on page 13.)
The oven was not preheated as
Preheat oven if called for in recipe.
the recipe calls for.
The recipe has never been
tested or is not from a reliable
source.
Use only tested recipes from a
reliable source.
The pans are not the type or
size recommended
in the
recipe.
Refer to a reliable cookbook for
recommended
pan type and size.
There is not proper air circula-
tion around pan when baking.
Allow 1 l/2 to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the broiler
drawer.
Adjust flame size to fit cooking
utensil.
Completely close broiler drawer.
24
Advertisement
