Advertisement
To replace:
1. Be sure the hinge arms are in the open
position. Be careful if pulling the hinges open
by hand. Hinges may snap back against the
oven frame and could pinch fingers.
2. Hold the door at the sides near the top. Insert
hinge arms into slots at the bottom of the door.
Insert arms evenly, as far as they will go,
3. If the door is not in line with the oven frame,
remove it and repeat the above steps.
4. Replace the screws on the oven door.
Removing
the oven
botto
The panel in the oven bottom can be removed for
cleaning or to light the burner pilot.
To remove:
1. Remove oven racks.
2 Remove the two hold-down screws at the rear
of the oven. If screws are too tight to remove
by hand, use a screwdriver.
3. Place fingers in slots in bottom panel and lift
rear of panel up and back until lip at the front
of panel is clear of front frame of oven cavity.
4. Lift bottom up and out.
To replace:
1. Place oven bottom panel in oven with the
back raised about 6 inches or until you can
insert the hold-down lip at front of panel under
the front frame of oven cavity.
2 Push back of oven bottom panel down fully
into place on metal flanges on rear wall and
insert the hold-down screws.
Advertisement
