Oven Light; Appliance Outlets (On Some Models); Oven Door - Whirlpool GERC4110SB0 Use & Care Manual

Oven Light

The oven light is a standard 40-watt appliance bulb. It will come
on when the oven door is open. When the oven door is closed,
press OVEN LIGHT to turn it on or off. It will not work during the
Self-Cleaning cycle.
To replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Plug in range or reconnect power.
Appliance Outlets
(on some models)
The 120v appliance outlets located on the control console may
be used to run portable appliances placed on countertops beside
the range.
The outlets operate independently and are not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop.
Damage to the portable appliance could result if the cooktop is
hot.
Appliance Outlet Circuit Breakers:
The circuit breakers for the appliance outlets on your range are
located under the cover on top of the control console. They are
rated for 12 amps.
Lift the cover by lifting the front edge at both ends.
On models equipped with a fluorescent cooktop light, remove the
fluorescent tube to gain access to the circuit breakers.
28

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.