Using The Self-Cleaning Cycle; S Etting The Controls - Whirlpool F195LEH Use And Care Manual

USING THE SELF-CLEANING CYCLE

S
ETTING THE CONTROLS
NOTE: Make sure the clock is set to the correct
time of day. (See "Setting the clock" in the "Using
Your Range" section.)
To start cleaning immediately:
1.
Press AUTO CLEAN.
This will automatically set a 3
Cleaning cycle.
NOTE: There will be a 30-minute cool-down
1 ⁄ hour before the cycle is over.
2
2.
Set the cleaning time (optional).
If you want a Self-Cleaning cycle longer or
shorter than 3 1 ⁄
pads to set the cleaning time you want. Press
the "up" (s) or "down" (t) pad(s) until a time
between 2 1 ⁄ -4 1
2
•
Use 2 1 ⁄ hours for light soil.
2
•
Use 3 ⁄ -4 ⁄ hours for average to heavy soil.
1 1
2 2
3.
Start the oven.
Make sure the door is closed all the way. If the
door is open even a little, it will not lock. Press
the door closed if needed. If the door is closed, it
will lock as soon as you press START/ENTER.
4.
After the Self-Cleaning cycle ends:
LOCKED goes off and the door unlocks.
5.
After the oven is cool, wipe off any residue or ash
26
1 ⁄ -hour Self-
2
hours, use the hour and minute
2
⁄ hours shows on the display.
2
with a damp cloth or
sponge. If needed,
touch up spots with a
mild abrasive cleanser
or cleaning sponge.
PRESS YOU SEE
AUTO
CLEAN
PRESS YOU SEE
HR MIN
(example shows 4
cleaning time)
PRESS YOU SEE
START
ENTER
5 SEC
YOU SEE
USING THE SELF-CLEANING CYCLE
CLEAN
TIME
CLEAN
TIME
1 ⁄ -hour
2
HEAT
ON
LOCKED CLEAN
TIME D TIME
CLEAN