Troubleshooting - Whirlpool 9763069 Use And Care Manual

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
Is the power supply cord unplugged?
Plug into a grounded outlet.
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Cooktop will not operate
Is the control knob set correctly?
Push in knob before turning to a setting.
On some models, is the Control Lock set?
See "Control Lock" section.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
Hot Surface indicator light stays on
Does the Hot Surface indicator light stay on after control
knob(s) have been turned off?
See "Cooktop Controls" section.
Cooktop cooking results not what expected
Is the proper cookware being used?
See "Cookware" section.
Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
Is the appliance level?
Level the appliance. See the Installation Instructions.
Oven will not operate
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
Has a delay start been set?
See "Timed Cooking" section.
On some models, is the Control Lock set?
See "Control Lock" section.
26

TROUBLESHOOTING

Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
On some models, does the cooling fan run during BAKE,
BROIL or CLEAN?
It is normal for the fan to automatically run when the oven is
in use. These helps cool the electronic control.
Oven indicator lights flash
Do the oven indicator lights flash?
See the "Display" section. If the indicator light(s) keeps
flashing, call for service. See "Assistance or Service" section.
Display shows messages
Is the display showing "PF" or flashing a time?
There has been a power failure. Clear the display. See
"Display(s)" section. On some models, reset the clock, if
needed. See "Clock" section.
Is the display showing a letter followed by a number?
Depending on your model, press OFF/CANCEL, OFF or
CANCEL/OFF to clear the display. See "Display(s)" section. If
it reappears, call for service. See "Assistance or Service"
section.
Self-Cleaning cycle will not operate
Is the oven door open?
Close the oven door all the way.
Has the function been entered?
See "Self-Cleaning Cycle" section.
On some models, has a delay start Self-Clean cycle
been set?
See "Self-Cleaning Cycle" section.
Has a delay start been set?
See "Timed Cooking" section.