Removing The Display Assembly; Prerequisites; Procedure - Dell Inspiron 3782 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.

Prerequisites

1. Remove the optical drive.
2. Remove the base cover.
3. Remove the wireless card.

Procedure

1. Lift the latch and disconnect the optical-drive connector-board cable from the system board.
2. Lift the latch and disconnect the optical-drive connector-board cable from the optical-drive board connector.
3. Lift the optical-drive connector-board cable off the system board.
4. Open the latch and disconnect the display cable from the system board.
5. Note the routing of the display cable and remove the cable from its routing guides on the heat sink and palm-rest and keyboard
assembly.
6. Remove the five screws (M2.5x5) that secure the left and right hinges to the system board and palm-rest and keyboard assembly.
7. Open the hinges.
60

Removing the display assembly

Removing the display assembly
computer. After working inside your computer, follow the instructions in
32
After