Troubleshooting - Husqvarna AUTOMOWER 105 Operator's Manual

Note:
Battery life is dependent on the length
of the season and how many hours a day the
product is operating. A long season or many
hours of use a day means that the battery
must be replaced more regularly.
Contact your local Husqvarna representative
to replace the battery.
5.3 Replace the blades
WARNING:
screws of the right type. Husqvarna
can only guarantee safety when
using original blades. Only replacing
the blades and reusing the screw
can result in a screw wearing during
mowing. The blades can then be
propelled from under the body and
cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the
best mowing result and low energy usage. All
3 blades and screws must be replaced at the
same time to obtain a balanced cutting

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on
messages, refer to the complete Operator's manual on Husqvarna's website
(www.husqvarna.com. If the same message appears often or if you still cannot find the reason
for the fault, contact your local Husqvarna representative.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such
as when gardening with a shovel. Breaks can also be due to the wire being stretched excessively
during installation. A wire break can be located by gradually halving the distance of the loop
where the break may have occurred, until there is only a very short section of the wire left. Refer
to the complete Operator's manual on Husqvarna's website (
1418 - 001 - 04.12.2019
Use blades and
6 Troubleshooting
system. Use Husqvarna original blades
embossed with the crowned H-mark logotype,
Warranty terms on page 34 .
refer to
5.4 To replace the blades
1. Switch off the product with the main
switch or the ON/OFF button.
2. Turn the product upside down. Place the
product on a soft and clean surface to
avoid scratching the body and the hatch.
3. Rotate the skid plate so that its holes
align with the screws for the blade.
4. Remove the 3 screws. Use a straight slot
or cross-tip screwdriver.
5. Remove each blade and screw.
6. Fasten new blades and screws.
7. Check that the blades can pivot freely.
www.husqvarna.com ).
Troubleshooting - 23